APLIKASI BIOAKTIVATOR LIMBAH TAHU DALAM PEMBUATAN PUPUK CAIR ORGANIK DARI SAMPAH PASAR DAN DAUN KERING

Authors

  • Hernowo Widodo Teknik Kimia, Fakultas Teknik, Universitas Bhayangkara Jakarta Raya
  • Laras Andria Wardani Teknik Kimia, Fakultas Teknik, Universitas Bhayangkara Jakarta Raya
  • Vicky Anderesta Kuswoyo Teknik Kimia, Fakultas Teknik, Universitas Bhayangkara Jakarta Raya

DOI:

https://doi.org/10.21111/atj.v5i2.6714

Keywords:

Bioactivator

Abstract

Organic fertilizers contain a lot of residual organic matter that has been decomposed and is ready for consumption by plants. The raw materials for organic liquid fertilizer used in this study were market waste, dry leaves, and the addition of three bio activators (tofu wastewater, Stardec, and EM4). The selection of tofu liquid waste is done because it is easy to obtain, cheap, and reduces environmental pollution. Therefore, the purpose of this study was to analyze the quality and quality of the manufacture of liquid fertilizer using the tofu industry's liquid waste bio activator compared to other bio activators. The method used in this research is the experimental manufacture of liquid fertilizer with anaerobic fermentation, which is then applied to the growth of kale. The results of this study are the quality and quality of the manufacture of liquid fertilizer using a liquid waste bio activator tofu industry is quite good, although it still does not meet the minimum Technical Requirements for Organic Fertilizer standards issued by the Decree of the Minister of Agriculture of the Republic of Indonesia Number 261/KPTS/SR.310/M /4/2019. This can be seen from the average height of the kale plant which is not much different from the use of popular bio activators on the market (EM4 and Stardec), where the average height yield is 6.72 cm on the seventh day.

Downloads

Published

2021-11-28

Issue

Vol. 5 No. 2 (2021): Agroindustrial Technology Journal

Section

Articles

License

The author whose published manuscript approved the following provisions:

1. The right of publication of all material published in the journal / published in the Agroindustrial Technology Journal is held by the editorial board with the knowledge of the author (moral rights remain the author of the script).

2. The formal legal provisions for access to digital articles of this electronic journal are subject to the terms of the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0), which means that Agroindustrial Technology Journal reserves the right to save, transmit media or format, Database), maintain, and publish articles without requesting permission from the Author as long as it keeps the Author's name as the owner of Copyright.
3. Printed and electronically published manuscripts are open access for educational, research and library purposes. In addition to these objectives, the editorial board shall not be liable for violations of copyright law.